09-11-2007 08:04 AM - edited 03-14-2019 11:29 PM
I get a dial tone when i call from outside the system to inside. It goes to dial tone straight away. Why has it stopped ringing? It gives the internal dial tone; if I dial my extension number that works! i need to fix this as soon as so it rings
Solved! Go to Solution.
09-11-2007 08:25 AM
I am assuming you are using H323, if so then make sure you have a dial-peer with this command:
direct-inward-dial
such as:
dial-peer voice 1 pots
incoming called-number .
direct-inward-dial
port 0/0/0:23
HTH,
Chris
09-11-2007 08:25 AM
I am assuming you are using H323, if so then make sure you have a dial-peer with this command:
direct-inward-dial
such as:
dial-peer voice 1 pots
incoming called-number .
direct-inward-dial
port 0/0/0:23
HTH,
Chris
09-11-2007 08:43 AM
Yep like an idiot id deleted the relevant dial peer. Its been a long day :(
09-11-2007 08:29 AM
That ususally indicates the call is using an inbound POTS dial peer without the direct-inward-dial command. Have you added any dial peers? Place a call and do a show call active voice brief to see what peers are being used.
Please rate helpful posts.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: