7600 does not make CEF in HARD

Unanswered Question

Hi!


I configured 1 VRF in a 7600. I need to send some packets from the global table to that VRF. I configured 2 ports, one in the global table and the other in the VRF and join the 2 ports with a crossover cable. To send the traffic to the VRF i used a PBR. It works but


the traffic switched by de VRF is CEF in software, not in hardare. This configuration is supported in 7600?


Thanks in advance!!!


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sultan-shaikh Tue, 01/08/2008 - 00:47
User Badges:
  • Bronze, 100 points or more

Hi,


How have you confirmed that the packets are not switched in the hardware?


I use this command to check the same.

"show ip hardware-cef"


Also as you might know that for hardware CEF switching the module should have specific ASICs for do that job.


Cheers


Actions

This Discussion