09-11-2007 09:36 AM
Hi!
I configured 1 VRF in a 7600. I need to send some packets from the global table to that VRF. I configured 2 ports, one in the global table and the other in the VRF and join the 2 ports with a crossover cable. To send the traffic to the VRF i used a PBR. It works but
the traffic switched by de VRF is CEF in software, not in hardare. This configuration is supported in 7600?
Thanks in advance!!!
01-07-2008 02:09 AM
CEF is Very necessary for MPLS to work.
01-08-2008 12:47 AM
Hi,
How have you confirmed that the packets are not switched in the hardware?
I use this command to check the same.
"show ip hardware-cef"
Also as you might know that for hardware CEF switching the module should have specific ASICs for do that job.
Cheers
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide