Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
565
Views
0
Helpful
4
Replies

Adding SNMP to a 2950 switch

whiteford
Level 1
Level 1

‎09-12-2007 05:33 AM - edited ‎03-05-2019 06:26 PM

I want our syslog server to receive logins, wr mems, config changes, etc from our 2950 catalyst switch how can I do this?

Labels:
0 Helpful
4 Replies 4

lgijssel
Level 9
Level 9

‎09-12-2007 05:48 AM

Please check the link below. It describes how to configure logging:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.1_19_ea1/configuration/guide/swlog.html

regards,

Leo

0 Helpful

whiteford
Level 1
Level 1
In response to lgijssel

‎09-12-2007 05:58 AM

I guess something like this should do it?

logging trap warnings

logging facility local4

logging 192.168.1.1

snmp-server community public123 RO

0 Helpful

royalblues
Level 10
Level 10

‎09-12-2007 06:03 AM

Syslog messages include only system generated messages and will not include the accounting information

You would require AAA for this

There is a new option called archive but i do not know whether it is supported on the 2950

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080454f73.html

HTH

Narayan

0 Helpful

whiteford
Level 1
Level 1
In response to royalblues

‎09-12-2007 06:54 AM

Or can I just log if a an Ethernet cable is pulled out or a port and the port goes down?

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card