09-12-2007 05:33 AM - edited 03-05-2019 06:26 PM
I want our syslog server to receive logins, wr mems, config changes, etc from our 2950 catalyst switch how can I do this?
09-12-2007 05:48 AM
Please check the link below. It describes how to configure logging:
regards,
Leo
09-12-2007 05:58 AM
I guess something like this should do it?
logging trap warnings
logging facility local4
logging 192.168.1.1
snmp-server community public123 RO
09-12-2007 06:03 AM
Syslog messages include only system generated messages and will not include the accounting information
You would require AAA for this
There is a new option called archive but i do not know whether it is supported on the 2950
http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080454f73.html
HTH
Narayan
09-12-2007 06:54 AM
Or can I just log if a an Ethernet cable is pulled out or a port and the port goes down?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: