Sip-ua can't send public address

Unanswered Question

I have a 827-4v that have a ADSL modem broke.I have a 837 that are a gateway of my network.The problem is that a sip-ua agent send a private IP of 827-4v for authenticate whit an external SIP this :


Contact: <sip:[email protected]:5060>

Expires: 3600

the sip-ua are configure in this mode :

authentication username 08611XXXX password XXXXXX

nat symmetric role passive

nat symmetric check-media-src

aaa username proxy-auth

retry invite 4

retry response 3

retry bye 2

retry cancel 2

registrar expires 3600


The 837 gateway router have a static NAT like this :

ip nat inside source static udp 5061 interface Dialer0 5061

ip nat inside source static udp 5060 interface Dialer0 5060

I have read every thing about a SIP NAT etc but I do know what I have to do!!!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
hadbou Tue, 09/18/2007 - 13:04
User Badges:
  • Bronze, 100 points or more

sip:[email protected]:5060 was what was sent, however this is not a valid SIP address as SIP addresses are supposed to be in the form of [email protected]. Because it is an invalid address the phone most likely reuses the previous

contact info.

paolo bevilacqua Tue, 09/18/2007 - 15:13
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Which IOS do you have on the 837?

Do you have access to IOS downloads to upgrade to latest image ?

It should replace the private address with the public one.

The IOS is c837-k9o3sy6-mz.124-5b.bin

I have a smartnet for upgrade the latest IOS image.

I have just 1 pubblic address and is for 837.

The solution will be this ? :

the " Hosted NAT Traversal for Session Border Controller " .

If yes I can try to upgrade my flash and download the c837-k9o3sy6-mz.124-15.T1.bin IOS flash image that have this feature.

If not....I don't know what I have to do...may be use the 837 like a modem for 827-4V ?


This Discussion