Multiple routes on 2811

Unanswered Question

I have inherited a nightmare and need to know if what I am trying to do is possible with what we have (2811 with Advanced Security 12.4). I have 2 sites connected via 2 point to point T1s, connected through 2 port HWIC in each router. Each site has 2 DSLs to connect to the internet, one site also has 1 internet T1, all of these connections are made via the network. I want to configure the routers to route traffic from a specific VLAN to one of the internet connections normally but failover to any of the other connections, including across the point 2 point network.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
emadehsan Wed, 09/12/2007 - 14:09


you can try HSRP for redundancy between routers and using EIGRP for their link activity.

also you can use tunnel interface on both router withy your desire destinations.


This Discussion