EoMPLS: Can I mix Dot1Q and port mode

Unanswered Question
Sep 13th, 2007

Dear all

I am looking at a project that would involve migrating Ethernet traffic off a L2 network ( V Large) onto an MPLS network and I am looking to support the following configuration:

A customer has a firewall connected via Dot1Q to a PE. Can I configure one VC from that PE to a remote PE and have that PE also terminate on a Dot1Q configured port. Also the customer would need to have a connection to an other remote device that is connected via port mode.

Is it possible for the customer attachment port ( running dot1Q) to connect to both Dot1q and port mode endpoints


Any help greatly appreciated


Regards

John Keane

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.

Actions

This Discussion