Question about trunk groups

Unanswered Question
Sep 13th, 2007
User Badges:

I'm used to configuring T1 and E1 circuits on gateways, so recently I've run into "trunk groups" on gateways provisioned with analog lines. I'm getting ready to set up ground-start analog DID lines (three of them). The three lines are going to be routing inbound calls for 10 DIDs, I'm wondering how a trunk group plays into this. Can someone help?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Thu, 09/13/2007 - 15:50
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

For incoming, trunk-groups are not useful as for outgoing, where they permit to reduce number of DP's very much, and few other things.

Still you can use them to apply for example a translation-profile to all three lines in a single command.

Hope this helps, please rate post if it does!


This Discussion