I just recently installed the eval version of ACS 4.1(1) Build 23. I also downloaded the same version of the remote agent and loaded that on a domain controller so I can authenticate against my AD. However, when following the directions to configure the remote agent on ACS I run into a problem.
The online instructions tell me to click on Network Configuration and click on "Add Entry" in the Remote Agents table. The problem is that I don't see a Remote Agents table within my Network Configuration page. What am I doing wrong?
Thanks in advance,
You have acs running on windows server , so there is not need to have remote agent installed.
Remote agent is needed with acs appliance and not with acs windows.
Please rate if helps