cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
384
Views
0
Helpful
3
Replies

SRST: Problem with E1 PRI on MGCP Gateway

ksander
Level 1
Level 1

Hi,

In a small one site solution where we have a single CCM 4.2.3 server, Voice Gateway in a 2801 with SRST connecting via PRI to the central office a problem occurs when the SRST function kicks in.

The PRI interface stays down and will not allow answer or placement of calls.

I know it is probably a simple config error, but I have not been able to sort it out.

Any help highly appriciated.

Thanks!

Klavs

3 Replies 3

icabrera
Level 4
Level 4

At the cco you have a good example, take a look and compare it with your solution, it can be helpful to see if you have a configuration error:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f8b31.shtml

Regards

AJAZ NAWAZ
Level 5
Level 5

Just a side note. Make sure the 'PRI Backhaul' ports UDP2427 & TCP2428 are not being blocked anywhere along the path lying in between the gateway and CCM.

Before that can you pls post the output from gateway show isdn status?. Try this command out few times since it is possible the status can change be continuously.

Let us know how you get on.

Ajaz

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: