CCM 4.x | SIP TRUNK

Peterson Cristovam · ‎09-14-2007

Hi.

The CCM 4.x works with SIP TRUNK?

The CCM 6.0 is Windows or Linux?

Thanks

Rob Huffman · ‎09-14-2007

Hi Peterson,

Here is the info you were looking for;

SIP Signaling/Trunk Interface Configuration Checklist (***CCM 4.1(3))

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edb28.html#wp1126527

Cisco offers two versions of Cisco Unified Communications Manager: Version 4.X on the Windows 2000 Operating System, and versions 5.X and ***6.0 as a Linux-based appliance model implementation.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/product_solution_overview0900aecd805e19e7.html

Hope this helps!

Rob

Peterson Cristovam · ‎09-14-2007

Ok.

So i need a sip proxy server.

I would like interconnect a PBX Siemens and CCM 4.x by SIP Trunk, but in the picture and document see that's need a SIP Proxy Server "in-the-middle".

Another question, in SIP Protocol, I can use a gateway like i use in MGCP? Redirecting call, controlling ports, etc, management by CCM?

Thanks

teodorgeorgiev · ‎09-16-2007

You do not need a SIP proxy server.

The CCM 4.x support SIP trunks (what it does not support is SIP endpoints).

A SIP trunk is where you directly send an INVITE message, without the need to REGISTER.

The Siemens HiPath 2030 are able to handle SIP trunks as well, if my memory serves me correctly.

eljose_lol · ‎06-25-2009

hi can you send the new link of this paper? http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edb28.html#wp1126527

it's current unable.

thx.