09-14-2007 08:41 AM - edited 03-13-2019 04:26 PM
Hi.
The CCM 4.x works with SIP TRUNK?
The CCM 6.0 is Windows or Linux?
Thanks
09-14-2007 10:04 AM
Hi Peterson,
Here is the info you were looking for;
SIP Signaling/Trunk Interface Configuration Checklist (***CCM 4.1(3))
Cisco offers two versions of Cisco Unified Communications Manager: Version 4.X on the Windows 2000 Operating System, and versions 5.X and ***6.0 as a Linux-based appliance model implementation.
http://www.cisco.com/en/US/products/sw/voicesw/ps556/product_solution_overview0900aecd805e19e7.html
Hope this helps!
Rob
09-14-2007 10:15 AM
Ok.
So i need a sip proxy server.
I would like interconnect a PBX Siemens and CCM 4.x by SIP Trunk, but in the picture and document see that's need a SIP Proxy Server "in-the-middle".
Another question, in SIP Protocol, I can use a gateway like i use in MGCP? Redirecting call, controlling ports, etc, management by CCM?
Thanks
09-16-2007 11:26 PM
You do not need a SIP proxy server.
The CCM 4.x support SIP trunks (what it does not support is SIP endpoints).
A SIP trunk is where you directly send an INVITE message, without the need to REGISTER.
The Siemens HiPath 2030 are able to handle SIP trunks as well, if my memory serves me correctly.
06-25-2009 10:58 AM
hi can you send the new link of this paper? http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edb28.html#wp1126527
it's current unable.
thx.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide