poor connection power AP1232AG-A-K9

Unanswered Question
Sep 14th, 2007
User Badges:

Cannot get more than 40 percent connecion power even when directly under the AP. Using Cisco CB21AG-A-K9 cards in Toshiba M4400 tablet. We set the cards to use the A radio at 5220Mhz CH 4 transmit power of 11dBm The A radio is a Air-RM22A. Do not understand why I cannot get better reception from this AP.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
irisrios Thu, 09/20/2007 - 11:11
User Badges:
  • Silver, 250 points or more

Interference and noise could cause reduced signal strength. Try changing the channel on the access point .

skernaghan@ecim.com Fri, 11/02/2007 - 09:24
User Badges:

Thanks,

Sorry for the delay. Had already looked at that and believe that the AC unit above the area may have been causing some problems, however, moved AP's and still getting same problem.???????

Scott Fella Sun, 11/11/2007 - 12:36
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Also make sure the antennas are in the correct connectors. If the Ap's are pretty high up, you will have a weaker signal directly under the AP.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode