877 COnfiguration

Unanswered Question
Sep 16th, 2007

I had been received a new DSL line from a service provider and configured two cisco 877 with ADSL interfaces. Configures the atm0 interfaces at both the ends...but even after in interface and line protocol status is up.. couldn't ping my local atm interface IPs assigned to Cisco 877.

What would be the Problem?

Please help me out ...


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Sun, 09/16/2007 - 04:57

Please send configuration and what you've been told by ISP about the circuit (VPI/VCI value, encapsulatin method).

syed_jeraisy Mon, 09/17/2007 - 00:19

Kindly find attached config for remote 877 router. Is it optional or Mandatory to use VPI/VCI values and encapsulation from service provider only ?

As in this case service provider has not provided any of these values , we used it as standard 0/35 . kindly please clear.

Paolo Bevilacqua Mon, 09/17/2007 - 03:05

Please ask ISP what encapsulation typoe (PPPoA, PPPoE, bridged rfc1483, etc).

If they cannot answer, ans if you need username and password to connect. If yes, we know that is some form of PPP. If not, we try the rfc1483 configs.


This Discussion