check a port for errors

Answered Question
Sep 16th, 2007
User Badges:

hi


howto check a port from Catalyst WS-C3550-12T for errors ?


kind regards

piotr

Correct Answer by JORGE RODRIGUEZ about 9 years 9 months ago

Piotr, from cli issue " show interface "

if you are particularly looking for specific interface issue "show interface fastethernet0/#" where # is the port number.


the "show interface fastethernet0/3"

will show interface stats for port 3, look for input errors, CRC, Runts, Giants statistics as these are indicators of communications errors between the port and the connected system. Same principle applies for gigabit interfaces if you have any uplinks. " show interface gigabitethernet0/#.


HTH

Jorge


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
JORGE RODRIGUEZ Sun, 09/16/2007 - 14:58
User Badges:
  • Green, 3000 points or more

Piotr, from cli issue " show interface "

if you are particularly looking for specific interface issue "show interface fastethernet0/#" where # is the port number.


the "show interface fastethernet0/3"

will show interface stats for port 3, look for input errors, CRC, Runts, Giants statistics as these are indicators of communications errors between the port and the connected system. Same principle applies for gigabit interfaces if you have any uplinks. " show interface gigabitethernet0/#.


HTH

Jorge


Actions

This Discussion