cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
466
Views
0
Helpful
3
Replies

Pix not booting

iqresource
Level 1
Level 1

Hi

My PIX 515E is not booting. It gets stuck. Below is the display after which it gets stuck. Pls help if it's a know issue to anyone.

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

32 MB RAM

PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

Thanks

Sarab

3 Replies 3

whisperwind
Level 1
Level 1

Sarab what does the CLI show you after this happens? I have seen times when a device hangs and goes into boot mode, which when i type load or reload - i forget actual command, just use the help feature it restarts fine.

Not sure why or how this happens but for me its usually a transient issue, give that a try perhaps it will be the same for you.

Tnx dude. problem resolved. Bad CMOS battery wasn't allowing pix to boot.

justin.jocewicz
Level 1
Level 1

You need to replace your CMOS battery and it will boot. You can then fix your time once it boots. Thanks.

Justin

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: