09-17-2007 03:03 AM - edited 03-14-2019 11:34 PM
Hi all,
We have an UC500 running and want a Linksys Sip phone to connect to it. The UC500 uses the CME IOS.
The phone registers itself correctly. I am able to call the extension. But when i pickup to answer, or to place an outbound call, i'll get an busy tone.
I've made the following additions to the UC500:
Voice register global
authenticate realm test.local
Voice register dn 14
number 214
voice register pool 14
id mac xxxx.xxxx.xxxx
number 1 dn 14
dtmf-relay rtp-nte
Username xxxxx password xxxxx
I hope somebody can point me in the right direction.
Albert
Solved! Go to Solution.
09-17-2007 03:27 AM
You need to specify voice-class under voice register pool.
I meant debug ccsip message,sorry.
09-17-2007 03:09 AM
Please configure a codec for the phone. If that fails, please collect 'debug sscip message' with 'term mon' and post it here.
09-17-2007 03:25 AM
Hi,
The codec configuration in the UC500 is as follows:
voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g729r8
The Linksys phone is also configured for G711u.
The debug sscip message isn't understood by the UC500. Is there any other debug i can post that should give us any helpfull info?
09-17-2007 03:27 AM
You need to specify voice-class under voice register pool.
I meant debug ccsip message,sorry.
09-17-2007 03:35 AM
voice-class codec 1 did the trick!
Your the master ;) Thank you.
09-17-2007 03:46 AM
Thank you for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: