Add static route to ACS SE

Answered Question
Sep 17th, 2007

How can I add a static route to my ACS SE appliance?

I am trying to get AAA working on a Cisco 871 that is a remote end-point of an ASA-to-871 s2s vpn. On the router I am using vlan1 as the source interface for tacacs.

My ACS server sits on my ASA's Management subnet, but the ACS' route back to the remote LAN is via its default gateway and the ASA's INSIDE interface. I need to get the ACS tacacs traffic to return via the ASA management interface.

Thanks in advance.

John

I have this problem too.
0 votes
Correct Answer by Jagdeep Gambhir about 9 years 2 months ago

John,

There is no way to set a static route in the ACS appliance. The only network parameters you can set are the ip address/subnet, default gateway, and dns servers.

Regards,

~JG

Please mark it resolved so other can benefit from it

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Jagdeep Gambhir Mon, 09/17/2007 - 14:39

John,

There is no way to set a static route in the ACS appliance. The only network parameters you can set are the ip address/subnet, default gateway, and dns servers.

Regards,

~JG

Please mark it resolved so other can benefit from it

Actions

This Discussion