Is the NM-1CE1T1-PRI the correct card for a frame circuit in a 2811 router?

Answered Question
Sep 17th, 2007
User Badges:

Hello,

I have a 2811 router and a NM-1CE1T1-PRI card. Is this the correct card for a frame cirucit? I have the card installed but I don't see a serial interface for it. Show ver does show the card:

1 Channelized (E1 or T1)/PRI port

I'm thinking I have the wrong card. But I'm not sure.


Thanks


Mike

Correct Answer by paolo bevilacqua about 9 years 7 months ago

It's fine. configure:

controller t1 x/y

channel-group 0 timeslots 1 24


the serial interface will appear and configure you FR in there.


Hope this helps, please rate post if it does!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
paolo bevilacqua Mon, 09/17/2007 - 11:06
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

It's fine. configure:

controller t1 x/y

channel-group 0 timeslots 1 24


the serial interface will appear and configure you FR in there.


Hope this helps, please rate post if it does!

MICHAEL CICCONE Mon, 09/17/2007 - 11:11
User Badges:

Thanks for the help... I see the serial interface now. In you example above channgel-group 0 timeslots 1 24. I could not put in the "24" Not sure I thats a big deal or not.


paolo bevilacqua Mon, 09/17/2007 - 11:29
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Ok, I missed a needed dash. Do:


interface x/0:0

shutdown


controller t1 x/0

no channel-group 0 timeslots 1

channel-group 0 timeslots 1-24


and you should be fine.


Thanks for the nice rating and good luck!


Paolo




MICHAEL CICCONE Mon, 09/17/2007 - 12:35
User Badges:

Paolo,

Some very stragge happen on the router. The command controller from config t is no longer there. I'm not sure what happen, any ideas?


MICHAEL CICCONE Mon, 09/17/2007 - 12:49
User Badges:

Paolo,

I figured out what happen. the command "card type" was missing. Not sure why. But once I put that back in the controller command was available.


Thanks again


Mike C.


Actions

This Discussion