09-17-2007 08:36 AM - edited 03-03-2019 06:47 PM
Hello,
I have a 2811 router and a NM-1CE1T1-PRI card. Is this the correct card for a frame cirucit? I have the card installed but I don't see a serial interface for it. Show ver does show the card:
1 Channelized (E1 or T1)/PRI port
I'm thinking I have the wrong card. But I'm not sure.
Thanks
Mike
Solved! Go to Solution.
09-17-2007 11:06 AM
It's fine. configure:
controller t1 x/y
channel-group 0 timeslots 1 24
the serial interface will appear and configure you FR in there.
Hope this helps, please rate post if it does!
09-17-2007 11:06 AM
It's fine. configure:
controller t1 x/y
channel-group 0 timeslots 1 24
the serial interface will appear and configure you FR in there.
Hope this helps, please rate post if it does!
09-17-2007 11:11 AM
Thanks for the help... I see the serial interface now. In you example above channgel-group 0 timeslots 1 24. I could not put in the "24" Not sure I thats a big deal or not.
09-17-2007 11:29 AM
Ok, I missed a needed dash. Do:
interface x/0:0
shutdown
controller t1 x/0
no channel-group 0 timeslots 1
channel-group 0 timeslots 1-24
and you should be fine.
Thanks for the nice rating and good luck!
Paolo
09-17-2007 12:35 PM
Paolo,
Some very stragge happen on the router. The command controller from config t is no longer there. I'm not sure what happen, any ideas?
09-17-2007 12:49 PM
Paolo,
I figured out what happen. the command "card type" was missing. Not sure why. But once I put that back in the controller command was available.
Thanks again
Mike C.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: