What commands can display IS-IS timers?

Unanswered Question
Sep 17th, 2007

The "show run" or "show start" commands display IS-IS timer settings which have been specifically configured on a router.

Is there any other show or other commands that display the IS-IS timers such as the current value for the "hello interval", "hello multiplier" or the calculated "hold timer" and other such timers?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
chrihussey Tue, 09/18/2007 - 07:34

"sh clns" & "sh clns protocol" may be the commands that would give you what you are looking for.

kevinoconnell Tue, 10/23/2007 - 19:08

The commands you identified provide exactly what I was looking for.



This Discussion