PSTN Emulation with CCM Lab Question

SBCdd7343 · ‎09-18-2007

For our internal voice lab we want to be able to simulate the PSTN.

If I have Call manager with two sites(both with MGCP gateways, DSP's and 1MFT-t1) can I make calls over the pstn links as long as I set one side up as the Network Side? Our goal is to use this setup to test SRST failover, AAR etc...

Or will I need a PSTN simulator to get this testing capabilities between Call Manager (4.1.3) and the gateways?

Thanks

gogasca · ‎09-18-2007

No need to setup a PSTN simulator.

can I make calls over the pstn links as long as I set one side up as the Network Side?

YES! T1s back 2 back can do it

u can also setup a third router.

That acts as PSTN swithc

You can do the following:

Site A Router 1 connected to PSTN Router

Site B Router 2 connected to PSTN Router

PSTN Router Router 3 with 2 T1 cards.

with that you can emulate all PSTN scnearios.

Actually a back to back should do it but I would use the previuos one.

wojtek · ‎09-18-2007

Yes, you can,

I always in similar situations (testing, classes, etc.) use additional router withe two E1/T1 PRI instraces, one IP Phone and CME configuration. This way I able to test calls between sites and calls to the PSTN (which in my situation is CME part of the router's configuration). I configue IP Phone (7960) with up to 6 characteristic DN such as emergency, local, long distance, international, toll free etc.

Regards

Wojtek