Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1058
Views
0
Helpful
1
Replies

blocking UDP port on the 2960 switch

lunarsystems
Level 1
Level 1

‎09-19-2007 12:44 PM - edited ‎03-05-2019 06:35 PM

Hello

I need to block udp port 1443 to 15 devices. The network is setup at the moment with an ACL list. Apparently this is not working and a VLAN configuration has been suggested.

Can anyone suggest a configuration because I have read that the lower end CISCO switches cannotselectively apply an ACL per VLAN.

Thanks

Andrei

Labels:
0 Helpful
1 Reply 1

amdil
Level 1
Level 1

‎09-24-2007 07:28 AM

Andrei,

You can use ACL per interface and per VLAN too. Please provide more details.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card