09-19-2007 01:08 PM - edited 03-09-2019 06:52 PM
I am trying to setup EZVPN to carry a GRE tunnel to a remote site so I can utilize EIGRP over this tunnel. The VPN is working fine however I can't get EZVPN remote to create any dynamic ACEs for my internal loopback for the GRE tunnel on the client side router. Any ideas on how to get a network that is not directly connected to the client PIX to show up in the EZVPN ACL?
The attached file provides a quick picture and configuration details.
09-25-2007 12:10 PM
Traffic can be routed from a VPN Client to the EzVPN server, then back out to another remote EzVPN server.
For configuring EzVPN Client and Server on the Same Router refer to
09-25-2007 12:17 PM
Both sides are using a PIX to run IPSec and that topology won't fit in here. But thanks for the suggestion.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: