EZVPN NEM - Can't get to an inside network on the client side.

pruhnke79 · ‎09-19-2007

I am trying to setup EZVPN to carry a GRE tunnel to a remote site so I can utilize EIGRP over this tunnel. The VPN is working fine however I can't get EZVPN remote to create any dynamic ACEs for my internal loopback for the GRE tunnel on the client side router. Any ideas on how to get a network that is not directly connected to the client PIX to show up in the EZVPN ACL?

The attached file provides a quick picture and configuration details.

aghaznavi · ‎09-25-2007

Traffic can be routed from a VPN Client to the EzVPN server, then back out to another remote EzVPN server.

For configuring EzVPN Client and Server on the Same Router refer to

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a008032b637.shtml

pruhnke79 · ‎09-25-2007

Both sides are using a PIX to run IPSec and that topology won't fit in here. But thanks for the suggestion.