VPN Client problem

Unanswered Question
Sep 20th, 2007
User Badges:

Hi there,


I have configured a remote access VPN for a customer which has a BT router at home.


The BT router assigns an address in the DHCP pool 192.168.1.0/24 to the customers laptop.


The VPN assigns an address in the VPN pool 192.168.100.0/24.


The 192.168.1.0/24 is also a subnet on his internal LAN.


Now, I believe that this 192.168.1.0/24 might be the problem why the customer can only access the internal network and not the Internet (I have split tunneling enabled).


I have asked the customer to change either of the sites but he says that there must be another solution.


Does anyone know of any other solution? I am using NAT transparency because there are too many servers on the internal network to use static NAT through the VPN.


Thanks in advance.


P



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
mfreijser Thu, 09/20/2007 - 04:54
User Badges:
  • Bronze, 100 points or more

This is a problem that i'm starting to see more often; same subnets in use at home-users and the corporate LAN.


I personally have found no solution for this problem, for as far as i know is this only possible with a LAN-2-LAN tunnel. See the following page for the solution for the same problem with a LAN-2-LAN tunnel:

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800b07ed.shtml


Regards,


Michael


Actions

This Discussion