cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1933
Views
5
Helpful
2
Replies

ethernet port on 2511 ???

rico_hao40
Level 1
Level 1

The 2511 should have a ethernet interface, "interface Ethernet0

ip address x.x.x.x 255.255.255.0

no mop enabled"

But in the box, I only see Console and AUX port? No ethernet?

Any idea? How can I connect to this box through LAN ?

Thanks

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

When you say, "in the box" I assume you mean you're looking at the physical chassis. The ethernet interface is there. It's an AUI interface (http://www.cisco.com/en/US/products/hw/routers/ps214/products_tech_note09186a00801f5d86.shtml). You will need an ethernet trasceiver to convert the AUI interface to something more modern (i.e. RJ45).

View solution in original post

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

When you say, "in the box" I assume you mean you're looking at the physical chassis. The ethernet interface is there. It's an AUI interface (http://www.cisco.com/en/US/products/hw/routers/ps214/products_tech_note09186a00801f5d86.shtml). You will need an ethernet trasceiver to convert the AUI interface to something more modern (i.e. RJ45).

Thanks.

Yes, I found the conveter AUI->RJ45. Now it works.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: