09-20-2007 12:30 PM - edited 03-13-2019 04:27 PM
Can anyone point me towards the documentation that talks about upgrading IPCC Express 4.0 to 4.5. The install guides for other versions talk about upgrades from previous versions but I can find a section in the 4.5 Install Guide or I am just missing it.
Any help is appreciated.
09-20-2007 03:25 PM
Hi Shane,
You are going to hate this :( Check out Page 5 of this doc;
Hope this explains!
Rob
09-20-2007 04:52 PM
Son of a Biscuit
Well that explains why I could not find any upgrade information anywhere. I even read thru that particular document quite a bit but I guess I neglected to see that part. Good find.
09-21-2007 04:26 AM
Hi Shane,
I was surprised to see this note as well! I'm not sure what the plan for this migration is but if you learn anything maybe you could let us know. I would try to engage my Cisco SE to help with this one :)
Take care,
Rob
03-17-2008 10:53 AM
I'm in the same boat right now where I have a 4.0 install. The PDF that was referenced is not available any more. Can someone tell me what page 5 says?
Thanks
Kenta
03-17-2008 01:55 PM
Hi Kenta,
Here is the clip :(
Support for new install only-Cisco CRS 4.5(1) supports a new installation
only. It does not support upgrading from a previous version of Cisco CRS. (see page 5)
Hope this helps!
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: