i know how to configure a routed port on a 3560/3750
interface gigabit x/x/x
ip x.x.x.x x.x.x.x
but which command i need, to configure a routed port on a catalyst 4006?
it is equipped with supervisor I and 2 modules, 34 and 48 ports.
modules use cat os, supervisor use ios.
(please note, i wish to have a routed port, not a port in a vlan with an ip address)
thanks in advance for help
In this way , basically your module in slot 3 WS-X4232-L3 is a router and if you want to do intervlan routing , that is the card you will need to configure.On the supervisor itself , you can neither create an SVI or a routed port.
Here is a sample config for doing routing via WS-X4232-L3 module.