Replacing VWIC-1MFT-T1 with E1

Unanswered Question
Sep 21st, 2007

I have a CME system which has installed a VWIC-1MFT-T1. The configuration has been completed with this card. It turns out the customer needs a VWIC-1MFT-E1. Is there anything I should be aware of when swapping these over?

I would usually save the running config, power down, replace the VWIC, then power up. Is there anything I would need to do before powering down to remove the vwic-T1 from my config? Would anything in the config interfere with the new VWIC-E1? What, if any, sections would be changed/removed?

This is the first time i've done a switch like this and i'm trying to make it go as smooth as possible.

Thanks for looking.

David

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion