Using loopback address for return packets

Unanswered Question
Sep 21st, 2007
User Badges:

We have setup our voip dial-peers to use the loopback address with the 'voice-class source" command. Thats ok for one direction. Now how do we setup the receiving end to use its loopback address. Is there some command to put on the dial-peer pots entry to force the use of the loopback address on the return packets.

PS In case you have not noticed I know next to nothing about voice, so please forgive if this is an easy, straight forward question.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
lagos Sun, 09/23/2007 - 09:12
User Badges:
  • Cisco Employee,

These commands on your loopback interface will source all H323 traffic from the loopback. You do not need the dial-peer voice-class command.


h323-gateway voip interface

h323-gateway voip bind srcaddr x.x.x.x


HTH.

jogillis Mon, 09/24/2007 - 12:22
User Badges:

There is no h323 gateway explisitly defined anywhere in the config.

paolo bevilacqua Mon, 09/24/2007 - 14:24
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

For H323, you would use the above config. For SIP, there are equivalent commands.

jogillis Thu, 09/27/2007 - 10:29
User Badges:

Thanks for the replies. I do not know enough to know whether I am using H.323 or sip. Will try the suggestions.

Thanks

Actions

This Discussion