hi
could you please help me to find these specification in cisco router and its part number
WAN Ports 8 WAN Ports
LAN Ports 8 LAN Ports
Throughput NAT Throughput up to 80 Mbits/sec; VPN Throughtput up to 60 Mbits/sec
Outbound Load Balance & Failover Outbound Load Balance by least load (byte/ packet/session/ IP), auto-learning, priority, round robin, weight round robin
Auto Failover Connection
Inbound Load
Balancing & Failover Inbound load balance by bytes, packet, session, & IP address
Supports SOA, NS, A, MX, CNAME, and PTR records
Auto Failover connection
Protocols Security: NAT, UPAP, CHAP
Network: TCP/IP, HTTP, DHCP, PPP, UPAP, Multi-session PPPoE, ARP Proxy
Routing: Static Route, RIP I & II
Connection: Static/Dynamic IP, PPPoE, PPTP
VPN PPTP & IPSec Pass Through
IPSec Tunnels : 50
Encryption: DES, 3DES, AES (128/192/256 bits)
Authentication : MD5, SHA1, SHA2 (256/384/512 bits)
Manual key & IKE (Internet Key Exchange)
Load Balance (Mesh Group)
Firewall NAPT (Network Address Port Translation)
DoS (Denial of Service)
Access Control by Group
Ping to Death
Port Scan
SPI (Stateful Packet Inspection)
ICMP Filter for WAN
Packet Filter
URL Block
Session Limit
System Filter Exception
QoS (Quality of Service)
Policy Priority set by source and destination IP, source and destination MAC address, and service types
Security Admin passwords
Authentication with UPAP and CHAP for PPPoE
Management via WAN & LAN port HTTP Web-based
SNMP
Email Alert
Syslog
Applications
Support MSN & Netmeeting
Support with H.323 VoIP products
Multi-session PPPoE
SMTP bind
UPnP
Virtual server
Multi-DMZ
Dynamic DNS
NAT status & connection list & alias
MTU changeable for WAN
Dial-on-demand & Auto-disconnect
MAC address clone
Transparent Bridge Mode
DNS Loopback
Any IP on LAN
SNTP
Firmware upgrade HTTP web based download
TFTP download