09-23-2007 03:49 PM - edited 03-11-2019 04:15 AM
i have up dated my backup pix from 6.3 to 7.0, there were a few error messages from the config.
is there a tool availble that you can input the 6.3 config and it produces the 7.0 config, so we can correct any possible errors before the live conversion?
09-23-2007 07:21 PM
Hi,
There's no tool to convert PIX 6.x to ASA 7.x configuration. When a Pix is upgraded from 6.x to 7.x SW automatically does that for you, looking at "show start error" output after upgrade will tell if there are any commands which are not converted.
Regards,
~JG
01-27-2009 07:54 AM
In this guide you can see all changes
http://www.cisco.com/en/US/docs/security/asa/asa70/pix_upgrade/upgrade/guide/pixupgrd.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: