cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
521
Views
0
Helpful
6
Replies

Problem with in. call ISDN PRI

ruslanmaorif
Level 1
Level 1

Hi,

I have are strange problem w/ incomming call on mgt8010->ISDN PRI->c3825->ccm5.1. So, 1-15 channels work fine, but 17-31 two-way no voice. Connection are established, no error, on debug isdn all..... but .... no voice.

Thank's for any help.....

6 Replies 6

What does the Show ISDN Service command display?

On all Layers is fine - ACTIVE.... MULTI_FRAME_ESTABLISH.... all ok

Global ISDN Switchtype = primary-net5

%Q.931 is backhauled to CCM MANAGER 0x0003 on DSL 0. Layer 3 output may not apply

ISDN Serial0/0/0:15 interface

dsl 0, interface ISDN Switchtype = primary-net5

L2 Protocol = Q.921 0x0000 L3 Protocol(s) = CCM MANAGER 0x0003

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 0 CCBs = 0

The Free Channel Mask: 0xFFFF7FFF

Number of L2 Discards = 0, L2 Session ID = 7

Total Allocated ISDN CCBs = 0

Hi,

I have a same problem. Could you solve this problem? How? Thank you very much.

Regards,

--

Alberto

Hi,

If anyone happen to get a solution for this issue? I have also the same issue gong on in my network..

Mohsin..

Please open new thread for new problem, and include FULL details about it.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: