Cisco Works - how to save changes made by Port assignment

Unanswered Question
Sep 24th, 2007


I am using Cisco Works VLAN Port assignment to make changes - for example change the VLAN on a certain port of a switch. How can I make sure that the changes are saved to the configuration? My changes worked for about 2 weeks and then were overwritten by the last configuration when the backup schedule took place.

Help please!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
David Stanford Mon, 09/24/2007 - 17:50

Are you copying the running config to startup?

A config backup should not over write your config.

tueffelberta Mon, 09/24/2007 - 21:29

Yesterday I entered my changes again and set the mark at "copy running to startup ios config". I did not do that while making the changes the first time. I wasn't sure if that mark was necessary???

David Stanford Tue, 09/25/2007 - 05:12

If you wanted it to be saved in nvram then you can mark it. If you don't then your changes won't be saved on a reload.


This Discussion