nat 0 config lost in asa after booting

Unanswered Question
Sep 26th, 2007

The nat 0 config is getting lost in asa after booting or during failover

model :asa 5540

release 8.02

previous release 7.22

Pl help as in 8.02 there is no bug related to nat-pat

Cisco Adaptive Security Appliance Software Version 8.0(2)

Device Manager Version 5.2(2)

Compiled on Fri 15-Jun-07 19:29 by builders

System image file is "disk0:/asa802-k8.bin"

Config file at boot was "startup-config"

INCALPIX-TPL up 12 hours 28 mins

failover cluster up 9 days 20 hours

Hardware: ASA5540-K8, 1024 MB RAM, CPU Pentium 4 2000 MHz

Internal ATA Compact Flash, 256MB

BIOS Flash AT49LW080 @ 0xffe00000, 1024KB

Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)

Boot microcode : CN1000-MC-BOOT-2.00

SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.01

IPSec microcode : CNlite-MC-IPSECm-MAIN-2.04

0: Ext: GigabitEthernet0/0 : address is 0019.2f8f.38b6, irq 9

1: Ext: GigabitEthernet0/1 : address is 0019.2f8f.38b7, irq 9

2: Ext: GigabitEthernet0/2 : address is 0019.2f8f.38b8, irq 9

3: Ext: GigabitEthernet0/3 : address is 0019.2f8f.38b9, irq 9

4: Ext: Management0/0 : address is 0019.2f8f.38ba, irq 11

5: Int: Not used : irq 11

<--- More --->

6: Int: Not used : irq 5

Licensed features for this platform:

Maximum Physical Interfaces : Unlimited

Maximum VLANs : 200

Inside Hosts : Unlimited

Failover : Active/Active

VPN-DES : Enabled

VPN-3DES-AES : Enabled

Security Contexts : 2

GTP/GPRS : Disabled

VPN Peers : 5000

WebVPN Peers : 2

Advanced Endpoint Assessment : Disabled

This platform has an ASA 5540 VPN Premium license.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion