09-26-2007 05:45 AM - edited 03-14-2019 11:44 PM
Hi all,
I just installed a MPX 2.0 server and it runs fine. But now I want to change the time on the server, because I misconfigured it in the first step...
I read in the documentation that it is not possible to change the clock without reinstalling the MPX server.
Does anyone know how I can change the clock without haveing to reinstall the whole server?
With kind regards,
Paul van den IJssel
Digacom
The Netherlands
09-26-2007 05:52 AM
If I remember right, you can use the "net" command from CLI to configure time.
HTH
Sankar
PS: please remember to rate posts!
09-26-2007 05:58 AM
Nope, I allready tried this :(
11-09-2007 09:41 AM
If you run the net command and select Option 8 do you see any listings for time servers? If not, you can set up to 3 NTP servers to point to.
08-07-2008 02:20 PM
Hi, I just did this.
SSH into the MPX box (or open a terminal session) elevate yourself to root level (type: SU)then use the date command to change the time:
# date -s "16:15:00"
then reboot the server (type: reboot)
after that the MPX server displays the correct time.
tested on version 2.0.3.35
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: