Caller NAME presentation on PRI - H323 G/W

Unanswered Question

I had a QWEST PRI and had Caller ID and NAME being presented.

I changed it to an AT&T PRI and I have the Caller ID displayed but NOT THE CALLER NAME.

I can see the Caller NAME in the debug isdn as a FACILITY IE message and QWEST was sending as a DISPLAY IE message. I called AT&T to check if they can send as a DISPLAY IE but they say they CANNOT. Has anybody got this done by AT&T / Bellsouth / SBC.

I cannot change it to MGCP as it is a PARTIAL PRI.

I already checked

http://www.ciscotaccc.com/kaidara-advisor/voice/showcase?case=K14016668

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion