DSPFARM status is DSPFARM_DOWN

Answered Question
Sep 26th, 2007

I can't figure out why a dspfarm on a 1760 is down and won't go up after I reconfigure it as follows:

sccp local FastEthernet0/0

sccp

sccp ccm 10.110.15.101 priority 1

sccp ccm 10.110.15.100 priority 2

sccp ip precedence 3

!

dspfarm transcoder maximum sessions 4

dspfarm confbridge maximum sessions 6

dspfarm

Have resources configured in CCM:

Cisco IOS Conference Bridge

CFB000dbceff9ec

Cisco IOS Media Termination Point

MTP000dbceff9ec

Can do an extended ping from the FE interface of the router to both CCM servers and vice versa.

Any advice is greatly appreciated.

Yefim

I have this problem too.
0 votes
Correct Answer by Rajesh Revuru about 9 years 1 month ago

Just try changging it on CCM to Cisco IOS Enhanced Conference Bridge and MTP.

It worked for me

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
sadbulali Wed, 10/03/2007 - 13:42

Can you send the config of the router and possibly a screen shot of the DSPfarm setup fomr CM?

y-sapozhnikov Thu, 10/04/2007 - 13:33

I tried to configure another router using the same settings but to no avail.

Here is the pertinent show and config:

sanrtr01#sh dspfarm

DSPFARM Configuration Information:

Admin State: UP, Oper Status: ACTIVE - Cause code: NONE

Transcoding Sessions: 2(Avail: 2), Conferencing Sessions: 1 (Avail: 1)

Trans sessions for mixed-mode conf: 0 (Avail: 0), RTP Timeout: 600

Connection check interval 600 Codec G729 VAD: ENABLED

sanrtr01#sh sccp

SCCP Admin State: UP

Gateway IP Address: 10.10.252.1

Switchover Method: IMMEDIATE, Switchback Method: GUARD_TIMER

Switchback Guard Timer: 1200 sec, IP Precedence: 3

Max Supported MTP sessions: 0

User Masked Codec list: None

Call Manager: 10.110.15.101, Port Number: 2000

Priority: 1, Version: 3.1 or Higher

Call Manager: 10.110.15.100, Port Number: 2000

Priority: 2, Version: 3.1 or Higher

Packet Voice DSP Module Slot 0:

Hardware Revision : 3.2

Part Number : 73-6731-01

Board Revision : A0

Deviation Number : 0-0

Fab Version : 03

PCB Serial Number : VIC09156XHF

DSP memory size(in kwords): 256

Type of DSP : TMS320C549

Product (FRU) Number : PVDM-256K-8=

Packet Voice DSP Module Slot 1:

Hardware Revision : 3.2

Part Number : 73-6726-01

Board Revision : A0

Number of DSP's : 1

DSP memory size(in kwords): 256

Type of DSP : TMS320C549

Product (FRU) Number : PVDM-256K-4=

sanrtr01#sh voice dsp

DSP DSP DSPWARE CURR BOOT PAK TX/RX

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT

==== === == ======== ========== ===== ======= === == ========= == ===== ============

C549 000 00 g711ulaw 9.4.0 Idle Idle 0 0 2/0 NA 0 498597/50595

7

C549 000 01 g711ulaw 9.4.0 Idle Idle 0 0 2/1 NA 0 29973/29766

C549 000 02 g711ulaw 9.4.0 Idle Idle 0 0 2/2 NA 0 0/22

C549 000 03 g711ulaw 9.4.0 Idle Idle 0 0 2/3 NA 0 0/21

Active Voice Call details

Current total analog signalling channels: 4

Current max allowed digital timeslot for voice: 0

Current active transcoding sessions: 0

Current free transcoding sessions: 2

Current active conferencing sessions: 0

Current free conferencing sessions: 1

Current number of DSP group: 1

Group 0:

Current allocated analog signalling channels: 4

Current free analog signalling channels: 0

Current allocated digital signalling channels: 0

Current free digital signalling channels: 0

Port(s) served: 2/0 2/1 2/2 2/3

Current Available MIPS: 300

SPMM DSPRM State Image D-sig D-sig A-sig A-sig Mips Voice/Xcode

Dsp Dsp allocate free allocate free Free Chan

0/0 0 UP FIXMC 0 0 4 0 100 0

0/1 1 UP CONF 0 0 0 0 100 0

1/0 2 UP XCODE 0 0 0 0 100 0

interface FastEthernet0/0

description **** Sandhills LAN ****

ip address 10.10.207.1 255.255.255.0 secondary

ip address 10.10.252.1 255.255.255.192

ip access-group 101 in

ip access-group 101 out

ip helper-address 10.0.15.246

speed 100

full-duplex

h323-gateway voip bind srcaddr 10.10.252.1

service-policy output voip

sccp local FastEthernet0/0

sccp

sccp ccm 10.110.15.101 priority 1

sccp ccm 10.110.15.100 priority 2

sccp ip precedence 3

!

dspfarm transcoder maximum sessions 2

dspfarm confbridge maximum sessions 1

dspfarm

Screenshots are attached.

Correct Answer
Rajesh Revuru Wed, 10/03/2007 - 14:14

Just try changging it on CCM to Cisco IOS Enhanced Conference Bridge and MTP.

It worked for me

Actions

This Discussion