I tried to configure another router using the same settings but to no avail.
Here is the pertinent show and config:
sanrtr01#sh dspfarm
DSPFARM Configuration Information:
Admin State: UP, Oper Status: ACTIVE - Cause code: NONE
Transcoding Sessions: 2(Avail: 2), Conferencing Sessions: 1 (Avail: 1)
Trans sessions for mixed-mode conf: 0 (Avail: 0), RTP Timeout: 600
Connection check interval 600 Codec G729 VAD: ENABLED
sanrtr01#sh sccp
SCCP Admin State: UP
Gateway IP Address: 10.10.252.1
Switchover Method: IMMEDIATE, Switchback Method: GUARD_TIMER
Switchback Guard Timer: 1200 sec, IP Precedence: 3
Max Supported MTP sessions: 0
User Masked Codec list: None
Call Manager: 10.110.15.101, Port Number: 2000
Priority: 1, Version: 3.1 or Higher
Call Manager: 10.110.15.100, Port Number: 2000
Priority: 2, Version: 3.1 or Higher
Packet Voice DSP Module Slot 0:
Hardware Revision : 3.2
Part Number : 73-6731-01
Board Revision : A0
Deviation Number : 0-0
Fab Version : 03
PCB Serial Number : VIC09156XHF
DSP memory size(in kwords): 256
Type of DSP : TMS320C549
Product (FRU) Number : PVDM-256K-8=
Packet Voice DSP Module Slot 1:
Hardware Revision : 3.2
Part Number : 73-6726-01
Board Revision : A0
Number of DSP's : 1
DSP memory size(in kwords): 256
Type of DSP : TMS320C549
Product (FRU) Number : PVDM-256K-4=
sanrtr01#sh voice dsp
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ========== ===== ======= === == ========= == ===== ============
C549 000 00 g711ulaw 9.4.0 Idle Idle 0 0 2/0 NA 0 498597/50595
7
C549 000 01 g711ulaw 9.4.0 Idle Idle 0 0 2/1 NA 0 29973/29766
C549 000 02 g711ulaw 9.4.0 Idle Idle 0 0 2/2 NA 0 0/22
C549 000 03 g711ulaw 9.4.0 Idle Idle 0 0 2/3 NA 0 0/21
Active Voice Call details
Current total analog signalling channels: 4
Current max allowed digital timeslot for voice: 0
Current active transcoding sessions: 0
Current free transcoding sessions: 2
Current active conferencing sessions: 0
Current free conferencing sessions: 1
Current number of DSP group: 1
Group 0:
Current allocated analog signalling channels: 4
Current free analog signalling channels: 0
Current allocated digital signalling channels: 0
Current free digital signalling channels: 0
Port(s) served: 2/0 2/1 2/2 2/3
Current Available MIPS: 300
SPMM DSPRM State Image D-sig D-sig A-sig A-sig Mips Voice/Xcode
Dsp Dsp allocate free allocate free Free Chan
0/0 0 UP FIXMC 0 0 4 0 100 0
0/1 1 UP CONF 0 0 0 0 100 0
1/0 2 UP XCODE 0 0 0 0 100 0
interface FastEthernet0/0
description **** Sandhills LAN ****
ip address 10.10.207.1 255.255.255.0 secondary
ip address 10.10.252.1 255.255.255.192
ip access-group 101 in
ip access-group 101 out
ip helper-address 10.0.15.246
speed 100
full-duplex
h323-gateway voip bind srcaddr 10.10.252.1
service-policy output voip
sccp local FastEthernet0/0
sccp
sccp ccm 10.110.15.101 priority 1
sccp ccm 10.110.15.100 priority 2
sccp ip precedence 3
!
dspfarm transcoder maximum sessions 2
dspfarm confbridge maximum sessions 1
dspfarm
Screenshots are attached.
