Disabling the LAN port on 7940/60 SIP Phones

TIMOTHY DAVIDSON · ‎09-26-2007

Is there a way to disable the LAN port on Cisco phones running the SIP load?

AJAZ NAWAZ · ‎09-26-2007

have you tried to edit the SIP.cnf file?

this is the parameter:

network_port2_type : shut

I'm not sure if this will work but I will try it and post the results.

Ajaz

TIMOTHY DAVIDSON · ‎09-27-2007

Thanx for the info. I'll try as well when I get the chance.

-Tim

AJAZ NAWAZ · ‎09-27-2007

actually - forget that. I don't think it's possible. Take a look at this:

<http://www.cisco.com/en/US/products/sw/voicesw/ps2156/products_administration_guide_chapter09186a00807f47f1.html>

---------------------------

network_port2_type

(Optional) Configures the device type that is connected to port 2 of the phone.

Valid values are Hub/Switch and PC. Default is Hub/Switch.

Note If the value is PC, port 2 can be connected only to a PC. If you are not sure about the connection, use the Hub/Switch default value. Specifying the PC option and then connecting port 2 to a switch results in spanning-tree loops and network confusion.

-------------

I know it might not help - but atleast you don't waste your time AND/OR end up with spanning tree loop.

regards

Ajaz