bri configuration

Unanswered Question
Sep 27th, 2007
User Badges:

please i have customer need to implemnt ccme and make voice call through bri VIC2-2BRI-NT/TE so please i need any example of configuration or any websites that talk about how to configure the bri port and the dial-peer

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Thu, 09/27/2007 - 03:19
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Do you have multiple BRI or a single one ?

If multiple BRI, put them under trunk-group and reference it as destination for DP.

The needed configuration would then be:

interface BRI0/2/0

no ip address

no logging event link-status

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn tei-negotiation preserve

trunk-group my-trunk

voice-port 0/2/0

no vad

compand-type a-law

Hope this helps, please rate post if it does!

mostafamossad Fri, 09/28/2007 - 02:52
User Badges:

please can u send for me a complete configuration or any refrence explain the configuration

paolo bevilacqua Fri, 09/28/2007 - 02:55
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

There are too many variables involved for sending complete configurations and hope that it will work.

If you have never configured CME, do the telephony-setup wizard, if you have problems explain here and someone will try to help.

mostafamossad Fri, 09/28/2007 - 03:25
User Badges:

i need also to know how can i determine if i need to configure the port in the network mode or in the terminal device mode


This Discussion