09-27-2007 03:13 AM - edited 03-14-2019 11:45 PM
please i have customer need to implemnt ccme and make voice call through bri VIC2-2BRI-NT/TE so please i need any example of configuration or any websites that talk about how to configure the bri port and the dial-peer
09-27-2007 03:19 AM
Do you have multiple BRI or a single one ?
If multiple BRI, put them under trunk-group and reference it as destination for DP.
The needed configuration would then be:
interface BRI0/2/0
no ip address
no logging event link-status
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn sending-complete
isdn tei-negotiation preserve
trunk-group my-trunk
voice-port 0/2/0
no vad
compand-type a-law
Hope this helps, please rate post if it does!
09-28-2007 02:52 AM
please can u send for me a complete configuration or any refrence explain the configuration
09-28-2007 02:55 AM
There are too many variables involved for sending complete configurations and hope that it will work.
If you have never configured CME, do the telephony-setup wizard, if you have problems explain here and someone will try to help.
09-28-2007 03:25 AM
i need also to know how can i determine if i need to configure the port in the network mode or in the terminal device mode
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide