09-27-2007 03:13 AM - edited 03-14-2019 11:45 PM
please i have customer need to implemnt ccme and make voice call through bri VIC2-2BRI-NT/TE so please i need any example of configuration or any websites that talk about how to configure the bri port and the dial-peer
09-27-2007 03:19 AM
Do you have multiple BRI or a single one ?
If multiple BRI, put them under trunk-group and reference it as destination for DP.
The needed configuration would then be:
interface BRI0/2/0
no ip address
no logging event link-status
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn sending-complete
isdn tei-negotiation preserve
trunk-group my-trunk
voice-port 0/2/0
no vad
compand-type a-law
Hope this helps, please rate post if it does!
09-28-2007 02:52 AM
please can u send for me a complete configuration or any refrence explain the configuration
09-28-2007 02:55 AM
There are too many variables involved for sending complete configurations and hope that it will work.
If you have never configured CME, do the telephony-setup wizard, if you have problems explain here and someone will try to help.
09-28-2007 03:25 AM
i need also to know how can i determine if i need to configure the port in the network mode or in the terminal device mode
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: