BRI into Hunt Group Problem

Unanswered Question
Sep 27th, 2007

Hi All

CME 4.1 system with 2 x 2 port bri cards installed.

currently we have a single hunt group which all incoming calls go into.

voice ports are using :

connection plar 1050

(which is hunt group pilot) to direct all incoming calls.

Hunt group works as expected when called internally, but external incoming calls seem to ring 2 phones simultanously instead of just 1! Then when it it reaches timeout (because of no answer) the next 2 numbers in the hunt group list start to ring.

It appears as if the system thinks there are two calls incoming instead of just 1.

Does anyone have any ideas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
aapedraza Thu, 09/27/2007 - 11:20

post your configuration just to make sure. you don't need to use connection plar on bri lines. You should receive incoming called number information automatically... for BRI is usually the 7 digit directory number. for PRI is usually the 4 digit extension code.

Paolo Bevilacqua Thu, 09/27/2007 - 11:57

For what is mentioned above, you likely need a translation profile, than can be applied easy if you have multiple BRi and make a trunk group for them.


This Discussion