acomiskey Thu, 09/27/2007 - 08:17

Well, that upgrade didn't go so well. Upgraded, rebooted and now cannot access it at all. Any ideas?

edit: Spoke too soon, rebooted again and gave it about 10 minutes. It's ok now.

Bradley Spencer Thu, 09/27/2007 - 08:20

Can't ping, SSH or anything to the device? Got console?

We have upgraded 5 so far today without any issues.

acomiskey Thu, 09/27/2007 - 08:25

I edited my post above. I just wasn't patient enough.

One question, now that you have the option for ASA 7.2 and IPS 6.0, is there a way to edit your existing 7.0 or 5.0 devices, which are now 7.2 and 6.0, or do you have to recreate them from scratch?

acomiskey Thu, 09/27/2007 - 08:28

Nevermind, I found it. "Change Version" next to "edit" on the devices page.

Unfortunately it only let's you change the ASA version, not the version of the IPS module in the ASA.

Actions

This Discussion