At the risk of looking like a fool, I need a small bit of help.
I have a 1841 with a public IP connected to a small /27 vlan which routes to a /18 vlan. However it does not want to work. I'm begining to suspect NAT as the problem, funny thing is I've done a few IOS vpn setups and have yet to have a problem, the only difference is this case has 2 vlans whereas normally the it is one vlan only. Can anyone spot any mistakes below?
FTR I've been tinkering with ACL 101,105 and 106
I've attched the config, the clients route table, ipconfig and a debug on the router.