Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
652
Views
0
Helpful
5
Replies

command macros possible in IOS?

thorsten.steffen
Level 3
Level 3

‎09-27-2007 10:35 PM - edited ‎03-03-2019 06:56 PM

Hello,

I very often use the a couple of commands in the same order on our ios routers.

Is there any possibility to create a macro or alias which runs then several commands.

What I mean is to enter simply one alias or macro name on the cli which then runs some commands like

show interface

show interface counter

show vlan

Best Regards,

Thorsten

Labels:
0 Helpful
5 Replies 5

kerek
Level 4
Level 4

‎09-28-2007 02:22 AM

Hi,

Yes it is possible with command alias.

http://www.cisco.com/en/US/docs/ios/12_0/configfun/command/reference/frgenral.html#wp1017391

Hope it helps, rate if does

Krisztian

0 Helpful

thorsten.steffen
Level 3
Level 3
In response to kerek

‎09-28-2007 03:25 AM

Hi,

if I understand the documentation of the alias command correctly you can only program a 1-to-1 alias.

What I am searching for is a macro where I can enter only one alias which then runs several commands.

Regards,

Thorsten

0 Helpful

santhosh.mc
Level 1
Level 1

‎09-28-2007 02:25 AM

Hi,

if your requirement is to run few set of commands on multiple routers. Then the best way is to use a utility called as Kiwi CAT. With this you can configure the required set of commands for mulitple devices and schedule it.

Regards

Santhosh M.C

Cable&Wireless

0 Helpful

thorsten.steffen
Level 3
Level 3
In response to santhosh.mc

‎09-28-2007 03:26 AM

Sorry,

but's I need it interactive when I am connected via telnet.

Regards,

Thorsten

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card