wireless 1310 intermittent issues

Unanswered Question
Sep 27th, 2007
User Badges:

we have a link between two 1310 bridges and for a few months everything was fine.

now, every so often we get high response times when running a ping. The average response normally is around 2ms peaking to 7ms but every so often it spikes to say 300ms and then 700ms. Also, Every so often we see that the link goes down and the logs say deauthenticated and then no response. we have to reboot the wireless bridges (BOTH OF THEM) then this works after a reset.


any ideas?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gmarogi Fri, 10/05/2007 - 05:42
User Badges:
  • Bronze, 100 points or more

There are several reasons for an intermittent connectivity issue to occur with a building to building Wireless bridge setup.


Reasons like RF Interference, Fresnel Zone, Clear Channel Assessment etc are there. The following document should give you a clear picture on this

http://www.cisco.com/en/US/products/hw/wireless/ps469/products_tech_note09186a0080508551.shtml

Actions

This Discussion